English pages are provided only to compare translations to original pages,
better looking pages can be browsed
at the Linux man-pages official site.
Linux Programmer's Manual (5)
gai.conf - getaddrinfo
(3) configuration file
A call to
might return multiple answers.
According to RFC 3484 these answers must be sorted so that
the answer with the highest success rate is first in the list.
The RFC provides an algorithm for the sorting.
The static rules are not always adequate, though.
For this reason,
the RFC also requires that system administrators should have the possibility
to dynamically change the sorting.
For the glibc implementation, this can be achieved with the
Each line in the configuration file consists of a keyword and its parameters.
White spaces in any place are ignored.
Lines starting with '#' are comments and are ignored.
The keywords currently recognized are:
- label netmask precedence
The value is added to the label table used in the RFC 3484 sorting.
If any label definition is present in the configuration file
is present, the default table is not used.
All the label definitions
of the default table which are to be maintained have to be duplicated.
Following the keyword,
the line has to contain a network mask and a label value.
- precedence netmask precedence
This keyword is similar to label, but instead the value is added
to the precedence table as specified in RFC 3484.
Once again, the
presence of a single precedence line in the configuration file
causes the default table to not be used.
- reload <yes|no>
This keyword controls whether a process checks whether the configuration
file has been changed since the last time it was read.
If the value is
"yes", the file is reread.
This might cause problems in multithreaded
applications and is generally a bad idea.
The default is "no".
- scopev4 mask value
Add another rule to the RFC 3484 scope table for IPv4 address.
By default, the scope IDs described in section 3.2 in RFC 3438 are used.
Changing these defaults should hardly ever be necessary.
The default table according to RFC 3484 would be specified with the
following configuration file:
label ::1/128 0
label ::/0 1
label 2002::/16 2
label ::/96 3
label ::ffff:0:0/96 4
precedence ::1/128 50
precedence ::/0 40
precedence 2002::/16 30
precedence ::/96 20
precedence ::ffff:0:0/96 10
This page is part of release 3.66 of the Linux
A description of the project,
information about reporting bugs,
and the latest version of this page,
can be found at
- SEE ALSO
This document was created by
using the manual pages.
Time: 21:43:04 GMT, July 12, 2014